TD Aircraft
Posted: Wed Sep 26, 2018 4:17 am
Release 2018_09_23:
(also during the previous playtest, i wasn't saying anything earlier as i was assuming this would be only a temporary glitch and will be normal again as usual in the current release).
Issue:
Selecting a damaged Apache or Orca in the TD mod and pressing the deploy key (F by default i think) will NOT send the selected (damaged) air unit to fly back to the nearest pad in order to repair anymore.
Motivation:
This changes air plays quite drastically. (jumping the cam back to cy will lose the selected damaged air units focus (select the cy); scrolling all over the map, not seeing the main army/priority frontline on screen, ect... is annoying since those are very dedicated hit n run units and need full attention and very short reaction times and regrouping)
Conclusion:
I hope this happened by accident and is not intended And my question: can this be fixed again?
(also during the previous playtest, i wasn't saying anything earlier as i was assuming this would be only a temporary glitch and will be normal again as usual in the current release).
Issue:
Selecting a damaged Apache or Orca in the TD mod and pressing the deploy key (F by default i think) will NOT send the selected (damaged) air unit to fly back to the nearest pad in order to repair anymore.
Motivation:
This changes air plays quite drastically. (jumping the cam back to cy will lose the selected damaged air units focus (select the cy); scrolling all over the map, not seeing the main army/priority frontline on screen, ect... is annoying since those are very dedicated hit n run units and need full attention and very short reaction times and regrouping)
Conclusion:
I hope this happened by accident and is not intended And my question: can this be fixed again?